Section 4 - Adjustments & Repairs; Drive Belt Replacement; Service Brake & Park Brake Adjustment - Snapper GROUNDS CRUISER GC9520KW Safety Instructions, Installation & Operator's Manual

SECTION 4 – ADJUSTMENTS & REPAIRS
WARNING
DO NOT attempt any adjustments, maintenance,
service or repairs with the engine running. STOP
engine. Set park brake. Shift transmission to
neutral. Remove key. Remove spark plug wire from
spark plug and secure away from plug. Engine and
components are HOT. Avoid serious burns, allow
all parts to cool before working on machine.
4.1

DRIVE BELT REPLACEMENT

1. Engine and all parts must be cool before
proceeding.
2. Remove key and disconnect spark plug wire.
3. Set park brake and shift transmission to neutral.
4. Roll belt off of driven clutch. See Figure 4.1.
DRIVE BELT
P/N 7-2935
DRIVEN
CLUTCH
FIGURE 4.1
5. Slide belt between bottom of drive clutch and
notched area in frame.
6. Drive clutch is spring loaded. Compress clutch
away from frame allowing clearance for belt.
7. Pull belt up between clutch and frame.
8. To install new belt, first compress clutch and
place belt between clutch and frame.
9. Slide belt between bottom of drive clutch and
notched area in frame and position on drive
clutch.
10. Roll belt onto driven clutch.
4.2
Brakes are critical to the safe operation of the machine.
Check the function of the brakes frequently. Refer to
Section "Maintenance – Check Brakes". If adjustment is
required, complete each of the following steps carefully.
Always verify that the brakes function properly after
performing any brake adjustments. Do Not operate the
machine if the brakes are not functioning properly.
DO NOT operate machine if brakes are not
functioning properly. Adjust, repair or replace as
necessary. Contact your local Snapper dealer for
assistance.
COMPRESS
LEFT BRAKE
ADJUSTER
DRIVE CLUTCH
23
SERVICE BRAKE
ADJUSTMENT
WARNING
1. Park machine on flat surface. Set park brake.
Remove key.
2. Locate left and right brake adjustment nuts.
Clearly mark the nuts so that you will be able to
count turns. See Figure 4.2.
FIGURE 4.2
3. Using 7/8" deep well socket, turn each nut 1/2
turn clockwise, tightening brake adjustment.
4. Check function of brake. Refer to Section
"Maintenance – Check Brakes".
5. If additional adjustment is required, turn each nut
1/2 turn clockwise and re-check brake function.
6. Repeat until brakes function properly. DO NOT
exceed two turns total and only make
adjustment in 1/2 turn increments. Over
tightening the brakes will lead to premature
wear and brake failure. Contact local Snapper
dealer for assistance.
7. After completing the brake adjustment and
verifying that they function properly, further fine
adjustment may be required to balance the action
of the left and right brakes.
& PARK BRAKE
RIGHT
BRAKE
ADJUSTER