Table of Contents
Advertisement
Machine Component Identification - Item #165923Z
Reference 1 – Air Cleaner
Reference 2 – Optional Wheel Kit
Reference 3 – Oil Filler Cap & Dipstick
Reference 4 – Vibration Isolation
Mount
Reference 5 – Oil Drain Plug
Reference 6 – 120V, 20A Duplex
Receptacle
Reference 7 – 120V, 30A Locking
Device Receptacle
Reference 8 – 120/240V, 30A Locking
Device Receptacle
Reference 9 – 120/240V, 50A
Receptacle
Reference 10 – Circuit Breakers
Reference 11 - 10.0 Gallon Gas Tank
Reference 12 – Engine Key Switch
Reference 13 - Choke Lever
Reference 14 – Oil Filter
Reference 15 – Muffler
Reference 16 – Battery Box
Reference 17 – Fuel Line Valve
Reference 18 – Generator Head
Reference 19 – Gas Cap with Gauge
REFERENCE GUIDE
Refer to your Honda engine manual for air cleaner care.
Optional heavy-duty wheel kit (Item # 165919).
Refer to your Honda engine manual.
The engine and generator head is mounted on rubber cylinders
that absorb most of the engine vibration. This feature eliminates
the tendency of the machine to "walk" which is common in
engine-powered equipment.
Refer
to
your
recommendations.
The generator has a control panel with two duplex (two
receptacles in a common housing) receptacles. Each duplex is a
120-volt (V) 20 amp (A) straight blade receptacle, National
Electrical Manufacturer's Association (NEMA) number 5-20R.
This receptacle accepts NEMA plug numbers 5-15P and 5-20P.
Each duplex is capable of drawing 20A at 120V.
This locking device is a 120V 30A NEMA L5-30R receptacle.
This receptacle accepts a NEMA plug number L5-30P.
This locking device is a 120/240V 30A NEMA L14-30R
receptacle. This receptacle accepts a NEMA plug number L14-
30P.
This receptacle is a 120/240V 50A NEMA 14-50R receptacle.
This receptacle accepts a NEMA plug number 14-50P. Use this
receptacle if installing a transfer switch.
This portable single phase generator has 1 - 50 amp (A) thermal
magnetic 2 pole breaker, 1 - 30 amp (A) thermal magnetic 2 pole
breaker 1 - 30 amp (A) push to reset circuit breaker, and 2 - 20
amp (A) push to reset circuit breakers. Circuit breakers protect
against electrical overloads.
Large tank allows for extended run capabilities. Always allow
room for gasoline expansion by not filling the gas tank completely
full.
The engine key switch is located on the front of the engine.
Always locate this switch and be familiar with its location before
operating the generator.
Used during cold starts. Refer to the starting/stopping instructions
and the Honda engine manual for usage.
Honda oil filter. Consult engine manual for change intervals.
This generator is equipped with a quiet style muffler. The muffler
is designed to allow moisture (condensation) to drain from the
bottom of the canister.
Included spark arrestor is shipped loose. See Spark Arrestor
Installation section of this manual for information.
The battery box provides protection for the battery, and will
accept the standard lawn tractor size battery (Group U1-7). The
engine requires a 12-volt battery. See battery section for sizing.
The generator tank has an ON-OFF valve mounted underneath
the tank. Always keep this valve closed when the generator is
not in use.
The electricity producing part of the generator.
The gas cap is extra large, creating a large hole for refilling and a
comfortable grip. You can always monitor the fuel level without
removing the cap by using the fuel level indicator built into the
gas cap.
9
Honda
engine
manual
Always check for loose fasteners.
for
oil
change
Advertisement
Table of Contents
