Lexus LC 500 2022 Owner's Manual, Quick Manual page 93

● If the garage door or other device does not operate, proceed to "Programming a
rolling code system".
5
Repeat the steps above to program another device for any of the remaining
®
HomeLink buttons.
Programming a rolling code system
■
2 or more people may be necessary to complete rolling code programming.
1
Locate the "Learn" or "Smart" button
on the garage door opener motor in
the garage.
This button can usually be found where
the hanging antenna wire is attached to
the unit. The name and color of the but-
ton may vary by manufacturer. Refer to
the owner's manual supplied with the
garage door opener motor for details.
2
Press and release the "Learn" or
"Smart" button.
3
Perform within 30 seconds after
2
performing .
3
Press and
®
HomeLink button (inside the vehicle)
for 2 seconds and release it. Repeat
this sequence (press/hold/release) up
to 3 times to complete programming.
If the garage door opener motor oper-
ates when the HomeLink
pressed, the garage door opener
motor recognizes the HomeLink
nal.
hold the desired
®
button is
®
sig-
92