Mitsubishi Electric Mr.SLIM PCA Series Service Manual page 36

Split-type, heat pump air conditioners

Hide thumbs Also See for Mr.SLIM PCA Series:

OPERATING PROCEDURE

13. Removing the heat exchanger

(1) Remove the air intake grille. (See Figure 1, 2)

(2) Remove the left and right side panels. (See Figure 3, 4)

(3) Remove the under panel. (See Photo 13)

(4) Remove the drain pan. (See Photo 14, 15, 16)

(5) Remove the pipe cover. (See Photo 17)

(6) Remove the pipe thermistors (TH2 and TH5) from each

holder. (See Photo 18)

(7) Remove the pipe band fixing screw and remove the

pipe band. (See Photo 21)

(8) Remove 3 screws from the heat exchanger and remove

the heat exchanger. (See Photo 22)

To avoid falling of the heat exchanger, be sure to hold

the heat exchanger by hand. For safety reasons, this

procedure must be performed by two persons.

HEAD OFFICE : TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN

Distributed in Mar. 2012 No.OCH501

Made in Japan

PHOTOS & ILLUSTRATIONS

Photo 21

Photo 22

Heat exchanger

fixing screws

Heat exchanger

New publication, effective Mar. 2012

Specifications are subject to change without notice.

Heat exchanger

Pipe band

Pipe band fixing

screw

Vane

Table of Contents