Table of Contents
Advertisement
10
www.aeg.com
• The indicators
go off.
• The indicator
flash.
• The display shows the current
setting: e.g.
3. Press
the setting.
4. Press the on/off button to confirm
the setting.
6.4 Use of rinse aid and multi-
tablets
When you activate the option Multitab,
the rinse aid dispenser continues to
release rinse aid. However you can
deactivate the rinse aid dispenser. In this
case the drying results may not be
satisfactory.
With the rinse aid dispenser deactivated,
the rinse aid indicator is always off.
How to deactivate the rinse
aid dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
start to flash and the display is blank.
2. Press
• The indicators
go off.
• The indicator
flash.
• The display shows the current
setting:
activated.
3. Press
= rinse aid dispenser deactivated.
The rinse aid indicator goes off.
4. Press the on/off button to confirm
the setting.
,
continues to
= level 4.
– The levels of rinse aid are
from 0A to 6A.
– Level 0 = no rinse aid is
released.
again and again to change
,
,
.
,
continues to
= rinse aid dispenser
to change the setting.
6.5 Acoustic signals
,
and
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and
2. Press
3. Press
4. Press the on/off button to confirm
and
until
,
and
6.6 How to set the colour of
the TimeBeam
,
and
The appliance must be in programme
selection mode.
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are several colours
available. The TimeBeam can also be
deactivated.
1. To enter the user mode, press and
2. Press
hold simultaneously
the indicators
,
start to flash and the display is blank.
• The indicators
go off.
• The indicator
flash.
• The display shows the current
setting:
= Acoustic signal off.
to change the setting.
= Acoustic signal on.
the setting.
hold simultaneously
the indicators
,
start to flash and the display is blank.
.
and
until
,
,
and
,
,
and
continues to
and
until
,
,
and
Advertisement
Table of Contents
