Panasonic SC-TMAX40 Operating Instructions Manual page 19

"NO PLAY"
"UNSUPPORT"
• There is no album or track in the USB device.
• Examine the content. You can only play supported format.
• The files in the USB device can be corrupted. Format the
USB device and try again.
• The system may have a problem. Switch off the system and
then switch on again.
"NOT SUPPORT MULTI CONNECT"
• The Bluetooth connection cannot be established.
®
Disconnect the existing connected devices and try again.
"NOT SUPPORTED"
• To use Karaoke effect in D-IN source, change the digital
audio output setting on the external equipment to PCM.
"PLAYERROR"
• An unsupported MP3 file has been played. The system will
skip that track and play the next one.
"REC ERROR"
• You disconnected the USB device during recording. Connect
the USB device and do recording again.
• An error occurred during USB recording. Disconnect the
USB device and then connect it again.
"REMOTE 1"
"REMOTE 2"
• The remote control and the unit are using different codes.
Change the code of the remote control.
– When "REMOTE 1" is shown, press and hold [OK] and
[ ] on the remote control for a minimum of 4 seconds.
– When "REMOTE 2" is shown, press and hold [OK] and [<]
for a minimum of 4 seconds.
"TRK FULL"
• The number of files has exceeded the supported limit.
"USB A NO DEVICE"
"USB B NO DEVICE"
• The USB device is not connected. Examine the connection.
"USB OVER CURRENT ERROR"
• The USB device is drawing too much power. Disconnect the
USB device, switch off the system and then switch on again.
• Check the connection, it may be caused by a faulty USB
cable.
"VBR"
• The system cannot show the remaining play time for variable
bit rate (VBR) tracks.
Remote control code
When other Panasonic equipment responds to the remote
control of this system, change the remote control code for
this system.
Preparation
Press [SELECT] repeatedly on the unit to select "AUX".
█ To set the code to "REMOTE 2"
1
Press and hold [SELECT] on the unit and [<] until
"REMOTE 2" is shown.
2
Press and hold [OK] and [<] for a minimum of
4 seconds.
█ To set the code to "REMOTE 1"
1
Press and hold [SELECT] on the unit and [
the remote control until "REMOTE 1" is shown.
2
Press and hold [OK] and [
control for a minimum of 4 seconds.
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Press and hold [1] on the unit until "RESET?" is
shown.
2
While you press and hold [1] on the unit, press
[SELECT].
"RESET" is shown.
After "– – – – – – – – –" is shown, the unit will switch
off automatically.
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
DEMO play
The unit will play built-in demonstration song for 1 minute.
1
Press and hold
"WAIT FOR DEMO PLAY" is shown while you press
and hold the button.
Demonstration song is played and "DEMOPLAY" is
shown.
2
Press [8] to stop the demonstration song.
] on the remote
for more than 2 seconds.
] on
19