Installation; Electrical Connection - Smeg 50's Style FAB38RPB Manual

Excessive ice has built up inside the
freezer compartment:
• The thermostat is set at too low a
temperature.
• The room temperature is too high.
• The door is being opened too often
or for too long.
• The door is not closing/sealing
properly.
• The door seal is damaged or dirty.
Clean or replace it.
• Hot foods have been placed inside
the freezer compartment.
Door hard to open just after closing:
• If you attempt to open the door again
just after closing it (especially the
freezer door), considerable strength
is required. This is due to the vacuum
created by the cooling of the warm air
which has entered the freezer.
The doors are misaligned:
• Check that the appliance is level.
• Level the appliance using its feet.
60

Installation

6 Installation

6.1 Electrical connection

• The appliance must be connected to
ground in compliance with electrical
system safety standards.
• Do not pull the cable to remove the
plug.
General information
• Check the mains characteristics
against the data indicated on
the plate. The identification plate
bearing the technical data, serial
number and brand name is visibly
positioned inside the appliance.
Do not remove this plate for any
reason.
• Make sure that the plug and socket
are of the same type.
• Avoid using adapters, gang sockets
or extensions as these could cause
overheating and a risk of burns.
• The plug must always be accessible
when the appliance is installed.
• Leave the appliance standing ver-
tically for at least two hours before
turning it on for the first time.
• If it is necessary to replace the
power cable, this must be performed
by an authorised technician from
Technical Support Service.
Power voltage
Danger of electrocution