Table of Contents
Advertisement
5. Operating the Appliance
The appliance is designed for use with cooking vessels of not less than 180mm in diameter and not greater than 250mm in
diameter.
After lighting, do not move the gas cylinder and the appliance around, as liquefied gas may enter the appliance from the gas
cylinder, causing it to flare (large yellow flames).
Always operate the appliance on a firm level surface with the gas cylinder in an upright position.
Lighting the Appliance using the piezo:
• Turn the control knob clockwise to the 'OFF' position.
• Turn the gas supply 'ON' at the cylinder.
• Push down the control knob and keep pressing whilst turning anti-clockwise to the 'Ignition' position. This should light the burner.
Repeat this several times until the burner lights. If not, wait at least 3 minutes and repeat this process.
• When the burner is lit, keep the control knob pressed for a few seconds, then release it.
• If the burner does not stay alight, repeat steps 3 and 4. Adjust the heat by turning the knob to the 'High/Low' position.
• To turn the stove 'OFF', turn the cylinder valve to the 'OFF' position and then turn the control knob on the appliance clockwise to the
'OFF' position.
•
Always close the cylinder valve after usuage. This will prolong the life of the regulator and prevent any gas leakages if the appliance is
not in use.
Warning: If the burner fails to ignite within 10 seconds, turn the control knob off (clockwise). Wait three minutes before attempting to
re-light with ignition sequence.
Lighting the Appliance with a match:
• To light the appliance, light a match or barbecue lighter, turn on the appliance valve after connecting to and opening the cylinder
valve, by turning the control knob (E) in an anti-clockwise direction. Light the appliance burners.
• Use the control knob to adjust the flame intensity to the desired level by turning the knob clockwise to decrease the flame and
anti-clockwise to increase it.
• Always light the match or the lighter first before opening the gas valve on the appliance.
6. General Maintenance
This appliance does not require scheduled maintenance.
• It is dangerous to use an appliance with a cracked or perished seal and / or hose. Inspect both seals and hose regularly and replace if
they are not in order, before using the appliance.
• If the appliance was in use, it will be hot. Allow to cool sufficiently before attempting any maintenance.
• The stoves are fitted with jets to regulate the correct amount of gas.
• Should the hole in the jet become blocked this may result in a small flame or no flame at all.
• Do not attempt to clean the jet with a pin or other such device as this may damage the orifice, which could make the appliance
unsafe.
Replacing a blocked jet:
• Ensure that the cylinder valve is closed, then disconnect the appliance from the gas cylinder.
• Remove the pot stand/cooking surfaces from the stove body (A).
• Turning the appliance upside down, unscrew the screws holding the bracket of the burner to the body (B).
• From the top now, you can safely remove the burners from the appliance.
• Unscrew the blocked jet from the valve with a suitable spanner and replace it with a new jet (C).
• Do not over tighten as this may damage the Jet. To re-assemble, reverse the above procedure.
• Do not use pliers on the jet as this may damage the jet making it unusable or impossible to remove.
503-0674 LEV6 (400, 400F) Mighty 4 Stove - User Manual (SA).indd 3
Fig. 6
3 3
GB
2021/02/23 08:34:27
Advertisement
Table of Contents
