What To Do If You See A Blank Screen - Epson PowerLite TW-100 User Manual

No Signal
Using the Projector
10
8. Press the button on your video source to start your video
Play
(if necessary).
9. If you've connected more than one video and/or computer source,
you may need to select a different source. Press the
button on the projector or one of the
remote control. (See "Switching Between Picture Sources" on
page 11 for more information.)
If you're projecting from a computer, and you see a New
Hardware Wizard message saying that it has found a
plug-and-play monitor, click
If the image is upside-down or reversed, you need to change the
option in the Setting menu. See page 35.
Projection
If a projected image fails to appear, see the next section for help.
Once you see your image, turn to page 12 for instructions on focusing
and making other image adjustments.
When you're ready to turn off the projector, follow the steps on
page 22.

What To Do If You See a Blank Screen

If you see a blank screen or a blue screen with the
after turning on your computer or video source, try the following:
Make sure the power light is green and not flashing and the lens
cover is off.
Make sure the cables are connected correctly, as described on the
Quick Setup sheet (or Appendix A, for computers).
Select a different source (if more than one is connected to the
projector) by pressing one of the
control. (See page 11.)
If you connected a computer, try restarting it.
If you're using a laptop, you may need to set up your system to
display on the projector screen as well as the LCD screen, as
described on page 53.
Source
buttons on the
Input
.
Cancel
No Signal
buttons on the remote
Input
message