Esc/Vp21 Command Codes; Installing The Projector - Epson PowerLite Pro Cinema 800 Quick Manual

Epson powerlite pro cinema 800: product information

Hide thumbs Also See for PowerLite Pro Cinema 800:

User manual (80 pages)

Notice (1 page)

Replacement parts (1 page)

Table Of Contents

Table of Contents

If you place the projector above or below screen level, you'll

have to tilt it up or down to aim the image at the screen; this

distorts (or "keystones") the shape of the image, but you can

correct it using the projector's Keystone function (see page 6).

If you place the projector off to the side, aim it straight ahead

(rather than at the center of the screen), then use the horizontal

lens shift dial to center the image. Do not place the projector

farther to the left or right than the edge of the screen, or you

will not be able to project a square (or rectangular) image.

Caution: To adjust the lens position, make sure you use the lens

shift dials. Do not try to move the lens manually, or you may strip

the gears.

Horizontal lens shift dial

Tip: You can display a test pattern to help you center the image on

the screen. Press the

Pattern

select

. You can use the feet to correct the angle of

Display Position

the image if it's tilted.

Installing the Projector

The illustrations below and in the next column show the

dimensions of the projector:

0.45 in.

15.98 in.

Vertical lens shift dial

button on the remote control, then

4.33 in.

12.17 in.

The included projector mount lets you attach the projector to

the wall or ceiling in the location that works best for your room.

Follow the instructions included with the mount to install the

projector, which weighs 11.5 pounds. The wall or ceiling

where you install it must be capable of supporting a weight of

58 pounds.

If you are planning to use an AV controller with the projector,

refer to the table of ESC/VP21 command codes below.