Using Projector E-Mail Alerts - Epson PowerLite 84 User Manual

note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Communication ON in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).
Using the Projector on a Network
58

Using Projector E-mail Alerts

When this feature is enabled, the projector sends you an e-mail alert if
it has any problems.
1. Press the button on the remote control, select the
Menu
menu, then press
Network
2. Choose
Network Configuration
3. Choose , then press
Mail
4. Highlight to receive email notifications, then press
On
5. Enter the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
6. Enter the SMTP server's port number. The default value is 25.
You can enter a numeric value from 1 to 65535.
7. Choose one of the
and the contents of the message that you will receive when a
problem or warning occurs. You can register up to three addresses.
You can enter up to 32 alphanumeric characters for the e-mail
address.
.
Enter
and press
. You see the following screen:
Enter
fields, then enter the e-mail address
Address
.
Enter
.
Enter