Using The Remote Control; Troubleshooting - Epson PowerLite 84 Quick Setup Manual

Using the remote control

Make sure the batteries are installed as shown (two AA batteries).
Turn projector
on and off
Turn off projector
display and sound
presentation
slides (USB
connection only)
You can use the remote control to operate the projector. With the USB cable,
you can use the remote as a wireless mouse. For more information on using the
remote control, see your User's Guide.

Troubleshooting

If you see a blank screen...
If you see a blank screen or the No signal message after turning on your
computer, check the following:
•
Make sure the power light on the projector is green and not flashing, and
the A/V Mute slide is open.
•
Press the Source Search button on the projector or the Search button
on the remote control to select the computer as the image source.
•
If you're using a Windows notebook, press the function key on your
keyboard that lets you display on an external monitor. It may be labelled
CRT/LCD or have an icon such as
Fn key while pressing it.
If the projector and notebook don't display the same
image...
Windows
Try using the CRT/LCD or
key lets you toggle between the LCD screen and the projector, or display on
both at the same time.
If that doesn't work, check your monitor settings to make sure both the LCD
screen and the external monitor port are enabled.
1
From the Windows Control Panel, open the Display utility. In Windows
® , right-click on the desktop and select Personalize, then select
Vista
Display Settings.
2
Click Settings, then click Advanced. In Windows Vista, click Advanced
Settings.
3
The method for adjusting the setting varies; you may have to click a
Monitor tab, then make sure the external Monitor port is set as your
primary display and/or enabled.
Change
Navigate
projector
menus
key as described above. On most systems, this
Choose which
source to display
Control projector volume
. You may have to hold down the