Resetting The Lamp Timer - Epson PowerLite 821p Product Information

Warning:
This product includes a lamp component that contains mercury
(Hg). Please consult your state and local regulations regarding
disposal or recycling. Do not put it in the trash.
7. Gently insert the new lamp. If it doesn't fit easily, make sure
it's facing the correct way.
Caution:
Do not touch the glass portion of the lamp assembly. Touching
the glass could result in premature lamp failure.
8. Once the lamp is fully inserted, tighten its screws.
9. Lower the lamp cover into place. (The opening should be
almost covered, and the top of the lamp cover should be
flush with the surface of the projector.) Then slide the cover
closed and tighten the screw.
10.Reset the lamp timer as described in the next section.
Epson PowerLite 821p Projector

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear
the
Replace the Lamp
Note:
Do not reset the lamp timer if you have not replaced the lamp. If
you do, the
Lamp Hours
hours that the lamp has been used.
1. Connect the power cable and turn on the projector.
2. Press the button on the remote control and select the
Menu
menu. Then press
Reset
3. Select
Lamp-Hours Reset
following:
4. Select and press
Yes
5. Press to return to the Reset menu or the
Esc
to exit the menu system.
9/04
message.
will not accurately reflect the number of
. You see the following:
Enter
and press Enter. You see the
.
Enter
Epson PowerLite 821p Projector
button
Menu
13
-