Neilsen CT3583 Quick Start Manual

DIESEL INJECtOR PULLER
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
 WARNING! Ensure Health and Safety, local authority and general
workshop practice regulations are adhered to when using tools.
WARNING! Always use caution when working around fuel

systems. The fuel in the fuel rail may be pressurised even if
the engine is not running.
 IMPORTANT: These instructions are provided as a guide only.
Always refer to the vehicle manufacturer's service instructions,
or a proprietary manual, to establish the current procedure and
data, also any warnings or cautions particular to the vehicle.
 DO NOT use the set if any parts are missing or damaged.
 DO NOT use this tool for any purpose other than that for which it is
designed.
 Switch off vehicle's ignition and disconnect the battery before
commencing work under the bonnet.
 You must follow the vehicle's service manual cautions when
working around the air bag system. If the cautions are not
followed the air bag may deploy unexpectedly even after the
ignition is turned 'off', resulting in personal injury.
 never lay tools on the vehicle's battery. This may short the
terminals together, causing harm to yourself, the tools, or the
battery.
 operate in a well ventilated area. Do not inhale fuel vapours.
 Wear approved eye protection. A full range of personal safety
equipment is available from your dealer.
 Wear suitable clothing to avoid snagging. Do not wear jewellery
and tie back long hair.
 Keep children and other unauthorised persons away from the
working area.
 Keep yourself, tools, and test equipment away from hot engine parts.
 Always keep a fire extinguisher close by, that is suitable for fuel/
electrical/chemical fires.
 NEVER smoke or have open flames near vehicle.
 Always relieve fuel pressure before disconnecting fuel lines from
injectors.
 use a rag to cover fuel line fittings, when connecting or
disconnecting fuel lines. Avoid contact with fuel.
 clean up all fuel spills immediately and dispose of all rags properly.
 Maintain the tool components in good and clean condition for best
and safest performance.
 When work on the vehicle is finished, ensure all connections on
vehicle are restored, and that there are no tools left in the engine
bay.
 replace tools in the carrying case and store in a safe, dry,
childproof location.
2. INTRODUCTION & CONTENTS
comprehensive set for removing citroen/Peugeot 2.0/2.2HDi 16v fuel
injectors. Allows the removal of seized injectors without the need to
remove the cylinder head. Bridge fits perfectly on the cylinder head
preventing damage to the area surrounding the injector. Supplied in
carry-case.
Contents: (refer to fig.1)
Item Description
1 Bridge
2 3 x Bridge Legs
3 2 x force Screws - Thread 17mm, 25mm x Pitch 1mm
4 force Screw nut
5 Injector Sockets 25mm, 29mm
6 Security Hex Key - 10mm
CT3583
fig.1
fig.2
CANNON TOOLS LTD
Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K.
For Citroen and Peugeot