Connections - Toshiba 65U6763DB Operating Instructions Manual

Connections

Connector Type
Scart
Connection
(back)
YPBPR
YPbPr Video
Connection
(back)
/ Video
HDMI
Connection
(bottom&side)
VGA
Connection
(bottom)
AUDIO IN
PC/YPbPr/
Back AV
Audio
Connection
(back)
SPDIF
SPDIF
(Optical Out)
Connection
(bottom)
BACK AV
Back AV
(Audio/Video)
Connection
R
(back)
L / Video
HEADPHONE
Headphone
Connection
(side)
USB
Connection
(back&side)
CI
Connection
(side)
LAN
Ethernet
Connection
(bottom)
(*)Subwoofer
Connection
(back)
(*) For external subwoofer connection
Cables
YPbPr Connection Cable
YPbPr/PC Audio Cable
Audio Video Cable
LAN / Ethernet Cable
English - 10 -
Device
See the illustrations on the left
side. To enable PC/YPbPr audio,
you will need to use the back
audio inputs
with a YPbPr/PC audio cable for
audio connection. If an external
device is connected via the SCART
socket, the TV may automatically
switch to EXT1 mode. When
receiving DTV channels
(Mpeg4 H.264) or while in Media
Browser mode, output will not be
available via the SCART socket.
When using a wall mounting kit
(available from a third party in
the market), we recommend that
you plug all your cables into the
back of the TV before mounting
on the wall. Insert or remove the
CI module only when the TV is
SWITCHED
OFF. You should refer to the
module instruction manual for
details of the settings. The USB
2.0 inputs on the back side
and on the left side of the TV
supports devices up to 500mA.
Connecting devices that have
current value above 500mA may
damage your TV. The USB 3.0
input (optional) on the left side of
the TV positioned above the other
USB input, supports devices up to
1A. When connecting equipment
using a HDMI cable to your TV,
to guarantee sufficient immunity
against parasitic frequency
r a d i a t i o n a n d t r o u b l e - f r e e
transmission of high definition
signals, such as 4K content, you
have to use a high speed shielded
(high grade) HDMI cable with
ferrites.
If you want to connect a
device to the TV, make
sure that both the TV
and the device are turned off
before making any connection.
After the connection is done, you
can turn on the units and use
them.