Install The New Lamp; Install The Lamp; Resetting The Lamp - Epson EMP-830 Quick Reference Manual

Install the new lamp.

Install the lamp

cover.

Resetting the lamp

operating time
Reset the lamp operating time as described in the following section.
After replacing the lamp, be sure to reset the lamp operating time from the configuration menu.
Do not reset the lamp operating time except after the lamp has been replaced. If you do, the lamp
operating time will no longer be displayed correctly.
Holding the lamp facing the correct way, insert the lamp
until it clicks into place then tighten the two fixing screws.
Slide the cover back to its original position and then tighten
the lamp cover fixing screw at the side of the projector.
• Install the lamp securely. If the lamp cover is removed, the lamp
turns off automatically as a safety precaution. Moreover, the lamp
will not turn on if the lamp or the lamp cover is not installed
correctly.
• This product includes a lamp component that contains mercury
(Hg). Please consult your state and local regurations regarding
disposal or recycling. Do not put in the trash.
1. Press .
The configuration menu is displayed.
2. Select "Reset" - "Lamp-Hours Reset" and press
3. Select "Yes" then press
The lamp operating time is reset.
.
.
19 17