Additional Safety Instructions For Model Steamforce Pro; Intended Use - WAGNER SteamForce Pro User Manual

SteamForce Pro
(0.3 bar) pressure cap as supplied. It is also a safety valve. NEVER block off this outlet.
NEVER remove the pressure cap when unit is boiling - switch off and wait for 5 minutes.
Do not use any caustic cleaners on the tank. Do not allow to boil dry. Do not overfill the
reservoir. Never detach the hose whilst the unit is switched on.
The appliance shall not be unattended while it is connected to the supply mains. The
appliance is not to be used if it has been dropped, if there are visible signs of damage or if it
is leaking. Keep the appliance out of reach of children when it is energised or cooling down.
Under no circumstances should you attempt to repair a unit unless qualified and authorised
to do so.

5. Additional Safety Instructions for model SteamForce Pro

When standing on the stripper always remain within the confines of the step/platform and
do not over-reach.
Maximum weight for standing on the unit is 127 kg (20 stone) and no more
than 1 person at a time.
Do not permit oil, grease or slippery material to accumulate on the step/platform.
Do not allow objects to accumulate on the step/platform.
Do not use a ladder or other device on the step to get greater heights.
Do not apply impact loads on the step/platform.

6. Intended use

Do not use this Stripper for any purposes other than those detailed in these instructions.
To ensure long life of the steam wallpaper stripper, clean your unit immediately and
thoroughly after each use.
Caution! - Check the state of your plaster before starting work.
Steam can loosen weak, porous or poorly bonded plaster - which also loosens
readily if cracked, holed or if steam plate is held in one position for too long
after the paper is soaked.
Weak plaster can normally be detected by tapping a few areas of the wall.
A hollow sound indicates that you should proceed only with extreme care -
stopping immediately if you hear a cracking sound or plaster starts to break
loose.
The steam stripper is safe for drywall/plaster board surfaces but whatever the
material, it is always wise to check a small area before starting work.
EN
7