Westinghouse W-003 Owner's Manual page 4

MOUNTING AND WIRING INSTRUCTIONS
CAUTION: For fixtures labeled for outdoor and wet location use, provide a water-tight seal
between the fixture and the mounting surface by using silicone or similar caulking.
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These
fixtures meet all UL specifications.
1. Turn off power at circuit box to avoid possible electric shock.
2. Thread nipple (A) into center hole on mounting bar (B) approximately
(see fig. 1).
3. Thread hex nut (D) onto nipple (A) approximately 1/4 inch and insert lock washer (C), then
thread nipple (A) onto mounting bar (B) and secure with hex nut (D).
4. Secure mounting bar (B) to outlet box (E) (horizontally or vertically, see fig. 1) with
outlet box screws (F) (not included).
5. Identify color coding of fixture wires (see figure 2 on page 11).
6. To connect wires, take black fixture wire (group A from fig. 2) and place evenly against
black outlet box wire. Do not twist wires.
7. Fit wire connector (G from fig. 1) over wires and twist until there is a firm connection.
If wire connector easily comes off, reattach wire connector and check again for a firm
connection (see figure 1).
8. Repeat steps 6 and 7 with the white (group B from fig. 2) fixture and outlet box wires.
9. Partially thread green grounding screw (H) into side hole (I) on mounting bar (B) (see fig.1.)
10. Wrap ground wire from fixture around green grounding screw (H), leaving enough excess
wire to then connect ground wire and outlet box wire with wire connector (G) (if applicable).
11. Tighten green grounding screw (H). Do not over tighten.
12. Tuck wires inside outlet box (E).
FIXTURE ASSEMBLY INSTRUCTIONS
1. Place canopy (M) over nipple (A).
2. Secure into place with cap nut (K).
3. Install lamp(s). Do not exceed recommended wattage.
4. Place diffuser (L) in holder (J) with lip of diffuser over the tab inside of holder (J).
5. Secure into place with thumb screw (N) (or if holder is threaded, screw holder into place).
Do not over tighten.
6. Turn power back on at circuit box.
4
1 / inch
4