Printer Setup; Unpack The Printer - Epson Stylus Photo 700 User Manual

Printer Setup

Printer Setup
Setting up your printer is easy. Just follow the simple steps on the following pages.
Before you set up your printer, make sure your system meets the requirements
listed in the Introduction of your User's Guide.

1 Unpack the Printer

Remove any packing material from the printer. See the Notice Sheet in the box for
details. Save all the packaging so you can use
it if you need to transport the printer later.
You need the following items to
set up your printer:
Your printer and paper support
Ink cartridges (black and color)
CD-ROM with your printer
software and EPSON Digital
PhotoLab
Printer cable (not included)
Place the printer flat on a stable desk near a grounded outlet. Leave plenty of room
in back for the cables and enough room in front for opening the output tray.
Do NOT put the printer:
In an area with high temperature or humidity
In direct sunlight or dusty conditions
Near sources of heat or electromagnetic interference, such as loudspeakers
or cordless telephone base units.
Be sure to follow all the Safety Instructions in your User's Guide.
2
Note:
To connect to a PC, you'll need a shielded, twisted-pair parallel printer
cable (6 to 10 feet long). To connect to a Macintosh, you'll need an
Apple ® System Peripheral-8 cable (Belkin brand recommended).
color ink
cartridge
printer
black ink
cartridge
paper support
CD-ROM
(located on the back of
this guide)