Skil CR541801 Owner's Manual page 17

f. If adjustment is necessary, loosen the bevel-adjustment knob. Place the saw in an upside-
down position on a workbench. Using a Philips-screwdriver, turn the 0° bevel-stop adjusting
screw until the foot is square with the saw blade.
Saw-Line Window (Fig.8)
For a 0° cut, align your line of cut with the left
notch in the foot at the 0° indicator.
For 45° bevel cuts, align your line of cut with
the right notch at the 45° indicator.
The saw-line window will give an approximate
line of cut. Make sample cuts in scrap lumber
to verify the actual line of cut. This will be help-
ful because of the number of different blade
types and thicknesses available. To ensure
minimum splintering on the good side of the
material to be cut, face the good side down.
Extension for Vacuum Cleaner
(Fig.9)
Y our tool is equipped with an extension (Φ1-
1/4'') for connection to a vacuum cleaner.
Choose a suitable vacuum-cleaner hose or use
an adapter, if necessary.
WARNING
with the lower guard or cutting operation.
LED Light (Fig.10)
Your tool is equipped with a LED light, located
behind the upper guard. This provides addition-
al light on the saw blade and the surface of the
workpiece for operation in lower-light areas.
The LED light will automatically turn on with a
slight squeeze on the trigger switch before the
tool starts running. It will turn off 8 to 12 sec-
onds after the trigger switch is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the LED light will rapidly flash.
Rest the tool for a while or place the tool and
battery pack separately under air flow for cooling.
Never allow a vacu-
um-cleaner hose interfere
Fig. 8
0° Indicator
45° Indicator
Fig. 9
Fig. 10
LED Light
17