Assembly And Adjustment - Black & Decker BDCS20 Instruction Manual

4. If the batteries do not charge properly—(1) Check current at receptacle by plugging
in a lamp or other appliance. (2) Check to see if receptacle is connected to a light
switch which turns power off when you turn out the lights. (3) Check that the charger
plug is fully inserted into the charger port on the tool. (4) If the receptacle is OK,
and you do not get proper charging, take or send the tool and charger to your local
BLACK+DECKER service center. See Tools Electric in yellow pages.
5. The tool should be recharged when it fails to produce sufficient power on jobs
which were easily done previously. Battery life may be greatly diminished if batteries
are discharged deeply. DO NOT CONTINUE using product with its batteries in a
depleted condition. Recharge discharged batteries promptly.
6. To maximize battery life:
a. Do not fully discharge batteries.
b. Fully recharge batteries after each use.
c. Store tool in a location where the surrounding air temperature is approximately
40°F - 75°F (4.5°C - 24°C).
d. Disconnect charger from tool after charge is complete.
WARNING: Fire Hazard. When disconnecting the charger from the tool, be sure to
unplug the charger from the outlet first, then disconnect the charger cord from the tool.
Safety Warnings and Instructions: Drilling and Driving
WARNING: Tool may stall (if overloaded or improperly used) causing a twist. To
reduce the risk of injury always expect the stall. Grip the tool firmly to control the
twisting action and prevent loss of control which could cause personal injury. If a stall does
occur, release the trigger immediately and determine the reason for the stall before
re-starting.

ASSEMBLY AND ADJUSTMENT

INSERTING AND REMOVING BITS
(FIGURE C)
• To install a bit, simply insert it into the
cavity in the hex spindle (3) as shown in
figure C. To remove the bit pull it straight
out.
FORWARD / REVERSE / LOCK OFF
SLIDER (FIGURE D)
• To select forward or reverse rotation, use
the forward / reverse slider (2) (see arrows
on the slider).
NOTE: When the forward / reverse slider is
in the central position the tool is locked off
to prevent accidental actuation or battery
discharge.
OPERATING INSTRUCTIONS
SWITCHING ON AND OFF
• To run the tool, press the switch (1).
• To stop the tool, release the switch.
• To lock the tool in the off position, move
the forward / reverse slider (2) to the central
position.
SCREW DRIVING
• Insert the appropriate screwdriver bit into
the hex spindle.
• Select forward or reverse rotation.
SCREW DRIVING NOTES:
• Do not use double ended screwdriver bits.
C
D
7
3
2