Table of Contents
Advertisement
Operating modes
en
ÇOperating modes
E xhaust air mode
O p e r a t i n g m o d e s
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air must not be discharged into a flue that is
Note:
used for exhausting fumes from appliances burning gas
or other fuels (not applicable to appliances that only
discharge the air back into the room).
Before conveying the exhaust air into a non-
■
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
If the exhaust air is conveyed through the outer wall,
■
a telescopic wall box should be used.
Air recirculation
The air which is drawn in is cleaned by
the grease filters and an activated
carbon filter, and is conveyed back into
the kitchen.
To bind odours in air recirculation mode, you
Note:
must install an activated carbon filter. The different
options for operating the appliance in air recirculation
mode can be found in the brochure. Alternatively, ask
your dealer. The required accessories are available
from specialist retailers, from customer service or from
the Online Shop.
6
1Operating the appliance
T hese instructions apply to several appliance variants.
O p e r a t i n g t h e a p p l i a n c e
It is possible that individual features are described
which do not apply to your appliance.
Switch on the extractor hood when you start
Note:
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Control panel
Explanation
Switches off the fan
D
1
Fan setting 1
2y Fan setting 2/Run-on function
3=
Fan setting 3/intensive mode
Switches the lighting on/off
B
Switching the appliance on and off
Switching on the appliance
Press button 1.
The extractor hood starts at fan setting 1.
Selecting the fan setting
Press the 2y or 3= button to set the corresponding fan
setting.
Switching off the appliance
Press the # button.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
To activate intensive mode, press and hold the
1.
3= button for 2 seconds.
To confirm the setting, the # button lights up and
the 3= button flashes.
To end intensive mode early, press the # button.
2.
Intensive mode runs for 10 minutes.Once this
Note:
time has elapsed, the appliance switches back to the
fan setting that was last selected.
Advertisement
Table of Contents
