Contec EPD-68A Manual

Screw Terminal (M3 x 68)
EPD-68A
* Specifications, color and design of the products are subject to change
without notice.
Features
Up to 68 signal lines can be connected.
The signal line from outside machinery can be connected to terminal
easily by only a screw (can use it for a round shape terminal, Y form
terminals).
Equipped with the [Spring-up] type terminal to prevent the terminal
screws from being lost.
The optional cable can be used to connect easily to the board/card.
Optimized configuration of board wiring.
Signal banks can be mounted on DIN rails.
Specifications
Item
Rated insulative voltage 30VAC rms
Rated current 0.3A
Compatible wiring 1.25mm
100VDC 500MΩ or later (Between terminals)
Insulative resistance
500VDC 1000MΩ or later (Relative to earth)
250VAC 60Hz One minute (Between terminals)
Voltage resistance
1000VAC 60Hz One minute (Relative to earth)
Connector HDRA-EC68FDT+ (mfd. by HONDA) equivalent
Compatible rail 35mm (wide) DIN rail
Operating conditions 0 - 50°C, 10 - 90%RH (No condensation)
Weight 380g
Standard RoHS Directive
Packing List
EPD-68A main unit...1
User's Guide...1
CAUTION
The option cable is not appended to the interface board/card and this product. Cable differs according to
board/card used. Be sure to check the manual or visit the CONTEC's Web site to buy an appropriate one.
EPD-68A
PLUG-IN Electronic GmbH • Am Sonnenlicht 5 • 82239 Alling • Tel.: +49 (0) 8141 3697-0 • info@plug-in.de • www.plug-in.de
Specification
2 (Max.) (stranded)
The products is a general purpose terminal fastened with screws, which
relays the I/O wirings of CONTEC interface board/card or card with a 68-
pin 0.8mm-pitch connector. The pins in connector correspond to their
respective terminals on the terminal strips on a one-to-one basis,
allowing you to easily connect the board/card to an external device via
the terminal strips. A round shape terminal, and a Y form terminal are
available together.
Note: To connect a board/card to the accessory, option cable can be
purchased separately.
Physical Dimensions
(Screw for attaching directly : M4 x 25L)
2-φ4.5
φ8.5
35
1
M3 x 6L 6.2 1.42 7.62
278.7
EPD-68A Connections
Board
Option cable
(Optional)
Screw Terminal
(1) Connect the interface board/card and the terminal unit using the separately
available option cable.
(2) Identify the destination for connection on the terminal unit and connect the
signal line from the external equipment. You can provide connection easily
just by tightening the screws.
220
68
34
External
device
Signal line from
external device
EPD-68A
Ver.1.00
[mm]
1