Table of Contents
Advertisement
Chapter 6: Advanced Chassis Setup
Expansion Card/PCI Slot Setup
The SC217HD+ chassis supports two low-profile PCI expansion slots for each node
for a total of four PCI slots in the system. To install a low-profile PCI card, perform
the following instructions.
1. Disconnect the chassis from any power source and lay the chassis on a flat
surface.
2. Pull the serverboard node drawer from the chassis.
3. Remove the PCI slot shield.
4. Insert the expansion card into the slot on the serverboard.
5. Secure the card to the chassis with a screw at the top of the card.
6. Close the expansion card PCI slot clip.
7. Close the cover, reconnect the power supply and power-up the node.
6-15
Advertisement
Table of Contents
