New Holland E115SR Workshop Manual page 6

SAFETY PRECAUTIONS
S
YY
WARNING
The proper and safe lubrication and maintenance for
this machine, recommended by Distributor, are
outlined in the OPERATOR'S MANUAL for the
machine.
Improper performance of lubrication or maintenance
procedures are dangerous and could result in injury
or death. Read and understand the MANUAL before
performing any lubrication or maintenance.
The serviceman or mechanic may be unfamiliar with
many of the systems on this machine. This makes it
important to use caution when performing service
work. A knowledge of the system and or components
is important before the removal or disassembly of any
component.
Because of the size of some of the machine
components, the serviceman or mechanic should
check the weights noted in this manual. Use proper
lifting procedures when removing any components.
Weight of components table is shown in the section;
SPECIFICATIONS.
The following is a list of basic precautions that must
always be observed.
1. Read and understand all Warning plates and
decal on the machine before Operating,
Maintaining or Repairing this machine.
2. Always wear protective glasses and protective
shoes when working around machines. In
particular, wear protective glasses when using
hammers, punches or drifts on any part of the
machine or attachments. Use welders gloves,
hood/goggles, apron and the protective clothing
appropriate to the welding job being performed.
Do not wear loose fitting or torn clothing. Remove
all rings from fingers, loose jewelry, confine long
hair and loose clothing before working on this
machinery.
3. Disconnect the battery and hang a "Do Not
Operate" tag in the Operators Compartment.
Remove ignition keys.
4. If possible, make all repairs with the machine
parked on a level, hard surface. Block the machine
so it does not roll while working on or under the
machine. Hang a "Do Not Operate" tag in the
Operators Compartment.
SAFETY PRECAUTIONS
5. Do not work on any machine that is supported
only by lift, jacks or a hoist. Always use blocks or
YY jack stands, capable of supporting the machine,
before performing any disassembly.
YY
Do not operate this machine unless you have read
and understand the instructions in the OPERATOR'S
MANUAL. Improper machine operation is dangerous
and could result in injury or death.
6. Relieve all pressure in air, oil or water systems
before any lines, fittings or related items are
disconnected or removed. Always make sure all
raised components are blocked correctly and be
alert for possible pressure when disconnecting
any device from a system that utilizes pressure.
7. Lower the bucket, dozer, or other attachments to
the ground before performing any work on the
machine. If this cannot be done, make sure the
bucket, dozer, ripper or other attachment is
blocked correctly to prevent it from dropping
unexpectedly.
8. Use steps and grab handles when mounting or
dismounting a machine. Clean any mud or debris
from steps, walkways or work platforms before
using. Always face to the machine when using
steps, ladders and walkways. When it is not
possible to use the designed access system,
provide ladders, scaffolds, or work platforms to
perform safe repair operations.
9. To avoid back injury, use a hoist when lifting
components which weigh 20 kg (45 lbs) or more.
Make sure all chains, hooks, slings, etc., are in
good condition and are the correct capacity. Be
sure hooks are positioned correctly. Lifting eyes
are not to be side loaded during a lifting operation.
10. To avoid burns, be alert for hot parts on machines
which have just been stopped and hot fluids in
lines, tubes and compartments.
11. Be careful when removing cover plates. Gradually
back off the last two capscrews or nuts located at
opposite ends of the cover or device and carefully
pry cover loose to relieve any spring or other
pressure, before removing the last two capscrews
or nuts completely.
12. Be careful when removing filler caps, breathers
and plugs on the machine. Hold a rag over the cap
or plug to prevent being sprayed or splashed by
liquids under pressure. The danger is even
0-6
Find manuals at https://best-manuals.com
S
YY
WARNING