Epson Stylus CX6400 Start Here Manual page 6

Macintosh
1
Insert your Stylus CX6400 software CD-ROM into your CD-ROM
or DVD drive.
2
If necessary, double-click the
EPSON CD-ROM icon,
then double-click the
EPSON installer icon.
You see this screen:
3
Click Install.
4
When you see the license
agreement, click Agree to continue.
Note: If you're installing on Macintosh OS X, you may see an
Authenticate message several times during installation. Enter your
administrator name and password, if necessary.
5
For Macintosh OS X: Continue with the following steps.
For Macintosh OS 8.6 to 9.x: Follow any on-screen instructions,
then continue with step 10.
6
Click Install at the EPSON Scan
Installer screen to install the
scanner portion of your software.
7
When the software finishes installing,
you see this screen. Click Quit.
8
Follow the on-screen instructions to
install additional software components.
Note: Click Quit when each part finishes installing.
9
When you see a message about
restarting your computer, leave in
the CD-ROM and click Restart.
10
After restarting, double-click the
EPSON CD-ROM icon, if
necessary, then double-click
the EPSON installer icon
to reopen the Software Installation
screen.
11
Click Install to install the
remaining software.
Note: It will take several minutes to install the remaining software.
Don't cancel the installation.
If you're installing on Macintosh OS 8.6 to 9.x, you may need to update
your Carbon Library. Follow the instructions on the screen.
12
At the end of the installation, click Exit.
13
When you see the Product Registration screen, register your Stylus CX
as instructed. At the last screen, click Quit or close your browser.
14
Make sure your Stylus CX6400 is turned on, then plug the USB cable
into any available USB port on your Macintosh.
Follow the instructions in the next column to add the Stylus CX to the Print
Center or Printer Setup Utility (for OS X) or the Chooser (for OS 8.6 to 9.x).
continue