Copying Photographs; Solving Problems - Epson Stylus CX5200 Start Here Manual

Copying Photographs

Select settings
Select menus
Use the
button to select settings. Press
1
Load special photo paper short edge first and glossy side (or whiter
side) up, then slide the edge guide against the paper.
2
Place your photo face-down on the glass,
with the top in the upper left corner. Move
your document about 0.1 inch from the top
and side edge so your entire photo is scanned.
3
Close the scanner lid.
4
Press
displayed.
5
Press the
or PSGP Paper (Premium Semigloss Photo Paper), depending on
which one you're using.
6
If you want to automatically resize your photo
to fill the page, press
Reduce/Enlarge on the display. Then press
the button to display Auto Fit Page.
7
Press to display your settings.
8
Press the
For more information about using the buttons or printing and scanning
from your computer, double-click the
icon on your desktop (or in the Dock on Mac OS X).

Solving Problems

If the red Error light is on, check the message on the Stylus CX. Try
turning the Stylus CX off and then back on. If your problem is listed here,
try these suggestions. For more information, see your software Help
or your on-screen EPSON Information Center.
The Found New Hardware
Wizard appears on
your screen.
You see an error message
when you try to print
or scan.
The Stylus CX
doesn't work.
Paper is jammed, or
doesn't feed correctly
or Menu button to select menus. Use the
until you see Quality&Paper
button until you see Matte Paper HW, Photo Paper,
Color Copy button. Your photo is copied and printed.
Click Cancel and follow the steps in
section 7. Disconnect the Stylus CX
before installing the software.
Make sure your Stylus CX is connected to
your computer, plugged into a power
source, and turned on.
Make sure you remove the tape from the ink
cartridge holder, as described in section 1.
Turn the Stylus CX off and then on again.
Slide back the transportation lock under the
lid to unlock the scanner. See section 2.
Make sure the ink cartridges are pushed
all the way down.
Make sure you're using the USB cable that
came with your Stylus CX. Try connecting it
to a different USB port on your computer.
Make sure your EPSON Stylus CX5200
software is installed correctly.
Remove and reinsert paper. Load paper
short edge first, against the right side, then
slide the edge guide against the paper.
Make sure the output tray is open.
Menu
to display the settings you have selected.
until you see
EPSON Information Center
Make more than one copy
Quality&Paper
Plain Paper-Norm
Reduce/Enlarge
Auto Fit Page
Photo Paper
Letter
Return to
menu or
cancel job
Color copy
or
1