Table of Contents
Advertisement
26
CHAPTER 3
Installation
Connecting Drop and Insert Cables
Installation Guide: 601, 602, and 604 Routers
Figure 19 Connecting the WAN Cable
Connect to Service
Provider's Demarcation
Point
Figure 19 shows the WAN cabling for a Model OmniAccess 602. A Model OmniAccess 601 only
has one WAN port. A Model OmniAccess 604 has four WAN ports.
WAN ports 1 and 2 can alternatively be used for drop and insert traffic. Port 1 is designated for
voice; port 2 is used for data traffic. Use two 26 AWG (minimum) category 5, twisted-pair
cables with RJ-48C connectors to establish this connectivity.
Figure 20 Connecting Drop and Insert Cables
Connect to Service Provider's
Demarcation Point
RJ-48C WAN Cables
To connect drop and insert cables, follow this procedure. Refer to Figure 20.
1
Insert the RJ-48C connector of one end of one WAN cable in WAN port 1 on the router.
2
Connect the other end of this cable to the local PBX port.
3
Insert the connector on one end of the second cable to WAN port 2 on the router.
4
Connect the other end of this cable to the Service Provider's demarcation point.
For information about configuring drop and insert, refer to the Command Reference Guide.
WAN Port 1
Connect to the Local PBX Port
Network Connections
Advertisement
Table of Contents
