Advertisement
3-2
DISASSEMBLY OF TOP COVER
- Remove the 4 screws out of side walls of top cover.
- Take top cover from set.
SERVICING OF THE FRONT PANEL
Disassembly of front panel
- Remove top cover.
- Remove the 3 fixing screws at upper side of fornt panel.
- Now the front panel can be taken off.
- Ensure during mounting that the 3 bosses of the set
frame engage with the appropriate holes of the
frontpanel.
Disassembly of control
+
display panel
- The control and display PCB can be detached by
removing the 7 screws 3Mx16 at the bottom of the
display panel.
- Then the control
+
display panel can be taken out of
the front.
- When mounting, make sure that the 3 bosses on the
front slip into the appropriate holes in the PCB.
SERVICING OF THE TRAY MECHANISM
Demounting the tray mechanism.
- Remove the top cover.
- Remove the front.
- Push the tray out of the mechanism.
- Remove the screw from the bottom of the set.
- Undo the 3 screws with which the loading has been
mounted into the set. Two screws are situated in front
and one in the centre at the rear.
- Lift the tray mechanism a little and undo the flexible
PCB from the connector by lifting the upper part of the
connector and taking the flexible PCB out Short circuit
the connections by means of a papercllp.
- Undo the 2 stocko connectors.
- Now take the tray mechanism out of the set.
cs
9 983
DEMOUNTING THE CDM
- Remove the complete disk hold-down.
- Turn the loading upside down.
- Support the CDM.
- Loosen the 2 screws on the metal bracket with which
the CDM is suspended.
- The CDM can now be removed.
- For servicing the CDM see Service Manual
CDM2/0500.
- Mounting is done in reverse order.
SERVICING THE SERVO + DECODER PANEL
- Remove top cover.
- Remove the front panel.
- Remove the tray mechanism.
- Remove the screw with which the chassis part is fixed.
- Remove the screw in the rear with which the CINCH
sockets are fixed.
- Remove the 2 screws on the PCB.
- Remove the screws from the transformer.
- The PCB now can be taken out.
- Mounting is done in reverse order.
REPLACEMENT OF TRANSFORMER FUSE
- For replacing the transformer fuse the transformer
must be desoldered from the main panel.
•
.C
0
C
Advertisement
