Mercedes-Benz GLA 180 Owner's Manual page 348

Using both hands, carefully reach into two
X
wheel trim openings and remove the wheel
trim.
Using wheel wrench :, loosen the bolts on
X
the wheel you wish to change by about one
full turn. Do not unscrew the bolts completely.
Jacking points
The jacking points are located just behind the
front wheel arches and just in front of the rear
wheel arches (arrows).
Changing a wheel
Take ratchet ring spanner ? out of the vehi-
X
cle tool kit and place it on the hexagon nut of
jack = so that the letters AUF are visible.
Position jack = at jacking point ;.
X
Ensure that the base of the jack is positioned
X
vertically under the jacking point.
Turn ratchet ring spanner ? until jack = sits
X
completely on jacking point ; and the base
of the jack lies evenly on the ground.
Turn ratchet ring spanner ? until the tyre is
X
raised a maximum of 3 cm from the ground.
Removing a wheel
!
Do not place wheel bolts in sand or dirt. The
threads of the wheel bolts and wheel hubs
could otherwise be damaged when the bolts
are tightened.
Unscrew the wheel bolts.
X
Remove the wheel.
X
Fitting a new wheel
G
WARNING
Oiled or greased wheel bolts or damaged
wheel bolts/hub threads can cause the wheel
345
Z