Enterasys WPIM-E1 Network Manual page 18

If NO LMI is selected, the following fields are displayed:
DLCI Address:
Circuit State:
PT#
Displays the application ports (bridge ports) available from the host
platform to the WAN. If the active protocol is PPP, Local Management
assigns only one application port per interface number (IF#). If the active
protocol is Frame Relay, Local Management assigns the available WAN
bridge ports from the host platform, one per DLCI.
You can assign WAN application ports to the 31 interfaces for the PPP
configuration that suits your needs. In a Frame Relay configuration, you
can assign all WAN application ports to one interface. In this example, the
remaining 30 interfaces would not have WAN application ports available.
The quantity of application ports for a Frame Relay network is
determined by the quantity of DLCIs (Data Link Connection Identifiers)
assigned to that Interface. This is determined either manually or by the
LMP (Link Management Protocol).
IF#
Displays the Interface that is associated with the application port.
LID
Displays the Link Identifier. If the active protocol is Frame Relay, the
Data Link Connection Identifier is displayed. If the active protocol for
this interface is PPP, then PPP appears in this field.
STATE
Displays the status of the application port. If the active protocol is Frame
Relay, this field displays the status as Active, Inactive, or Disabled (for No
LMI). If the active protocol is PPP, this field displays UP (for active) or
DOWN (for inactive).
WPIM-E1 LOCAL MANAGEMENT GUIDE
THE WAN INTERFACE CONFIGURATION SCREEN
This field can be set to values from 0-1023. The
values 0-15 and 1008-1022 are reserved DLCI
addresses.
Toggles between Active, Inactive and Invalid.
2-9