Graco A Series Instructions And Parts List page 5

5. As the wiper plate (K) nears the top of the pail, the
seal between the wiper and pail will decrease and
the plate may not come completely out of the pail.
If you are using Stainless Steel W iper Plate
222–909, push the long handle (P) back down and
rotate it 45 counterclockwise to lock it.
The elevator will lift the pump and pail together. Let
the elevator rise to its maximum height, so the
hanger (H) on the cart handle is below the hook (J)
on the elevator frame, then just pull the pail off the
plate.
N
3n
L
F
15
G
K (Model 222–812)
Fig. 2
Operation
NOTE: If the plate is stuck at the bottom of the pail
and doesn't come out at all, the elevator will pull the
pail up along with the plate. If this happens, allow the
elevator to rise to its full height, then open the wiper
plate vent (M). This will make it possible to pull the pail
off the plate. Check for a blockage in the air release
line, as explained on page 6.
6. Place the full pail on the cart base and position as
explained at left.
Detail Showing
Hanger and Hook
(Elevator Lowered)
Detail Showing
Hanger and Hook
(Elevator Raised)
J
M
H
0252A
H
J
0258
Detail Showing
Stainless Steel Wiper Plate
222–909
M
0259
P
01115