Hardware Description - D-Link DVG-4088S User Manual

Hardware Description

Front Panel
Power Indicator: Green light indicates a normal power supply.
Run Indicator: Blinking green light indicates normal operation.
Alarm Indicator: When the system starts up, the red light will blink. It also indicates the
gateway's abnormal operation.
Phone 1 – Phone 8 stands for Port 1 – Port 8: Connect to your analog telephone,
Line 1 – Line 8 stands for Port 9 – Port 16: Connected to your original telephone line on
the wall jack with RJ-11 cable.
WAN stands for the WAN Port Indicator.
LAN stands for the LAN Port Indicator.
When starting up the system, the Alarm, Run, and Power indicators will light up.
After about 40 seconds, the Alarm indicator will go off, the Run indicator will blink
in green, and the Power indicator will stay green under normal operational
conditions. If the Alarm indicator continues to blink, it means the system is
currently communicating with ISP and has yet to obtain an IP address.
When the WAN is connected, the WAN indicator will light up in green and if data is
being transmitted over the Internet, the indicator blinks in green and orange.
Rear Panel
NOTE: Do not connect FXS ports to each other. Also, do not connect any FXS port
directly to a PSTN line or internal PBX. If any of these are done, your 16/32 may be
damaged.
Restore to factory default: (IP address, User's. Name and Password)
(1) Pull off the power plug.
(2) Press reset (do not let go of the reset button).
(3) Plug the plug back into the socket (do not let go of the reset button).
(4) Let go of the reset button after 6 seconds. Factory settings will be restored.
3