Table of Contents
Advertisement
Electrical Connection
Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
Should the appliance power supply cable
need to be replaced, this must be carried
out by a Service Force agent. The manuf-
acturer declines any liability should this
safety measure not be observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance's
rating plate. The rating plate is located at the top of the
rim of the open door.
Mod. ..........
Prod. No. ...........
Ser. No. .........
P0042 BD
This machine is designed to operate on a 220-240 V, single-
phase, 50 Hz supply.
Check that your domestic electrical installation can take the
maximum load required (2.2 kW), also taking into account
any other appliances in use.
I I m m p p o o r r t t a a n n t t ! !
When the appliance is installed the power supply cable must
be easily accessible.
The manufacturer declines any responsibility for
damage or injury through failure to comply
with the above safety precaution.
Should the appliance power supply cable need to
be replaced, this must be carried out by our
Service Centre.
The plug must still be accessible after the
appliance has been installed
The appliance should not be connected to
the electrical supply by means of an
extension cable.
The power supply cable must be easily accessible after
installing the appliance.
Permanent connection
In the case of permanent connection it is necessary
that you install a double pole switch between the
appliance and the electricity supply (mains), with a
minimum gap of 3mm between the switch contacts and
of a type suitable for the required load in compliance
with the current electrical regulations.
10
Advertisement
Table of Contents
