Table of Contents
Advertisement
Embedded Intel® Atom™ Processor N2800 with Intel® NM10 Express Chipset Development Kit User's Manual
For more information about
Thin mini-ITX form factor
3.4
Jumper Block
CAUTION
Do not move the jumper with the power on. Always turn off the power and unplug the
power cord from the computer before changing a jumper setting. Otherwise, the board
could be damaged.
Figure 20 shows the location of the jumper block. The 3-pin jumper block determines
the BIOS Setup program's mode. Table 38 describes the jumper settings for the three
modes: Normal, Configure, and Recovery. When the jumper is set to Configure mode
and the computer is powered-up, the BIOS compares the processor version and the
microcode version in the BIOS and reports if the two match.
Figure 19. Standard-Height Back Panel I/O Shield
Refer to
http://www.formfactors.org/developer%5Cspecs%5CMini_ITX_
Spec_V2_0.pdf
71
Advertisement
Table of Contents
