Starting The Engine - North Star M165930R Owner's Manual

After you have completed the pre-start checklist procedures, you are ready to start the engine.
To start the engine:
1) Disconnect all loads to the generator.
2) Turn the fuel line valve to the ON position. The fuel valve is located underneath the fuel tank.
3) Start the engine:
a) Using electric start -
i) Turn the engine starting key to the START position and hold it there until the engine
starts.
ii) Release the key when the engine starts or after 10 seconds.
iii) If the engine does not start after 10 seconds, wait 15 seconds before attempting to start
again.
iv) If the engine will not start, consult the "Troubleshooting" section of this manual.
b) Using recoil start –
i) Turn the engine starting key to the RUN position.
ii) Pull the starter grip lightly until you feel a strong resistance, then allow starter cord to
return to the initial position.
iii) Push down the decompression lever. The lever is located on top of the engine and is
colored RED.
iv) Now pull out the starter cord briskly and rapidly with both hands.
v) Allow starter cord to return slowly.
vi) If the engine will not start, consult the "Troubleshooting" section of this manual.
4) Under long, continuous-run operating conditions, be prepared to:
a) Check and refuel the engine on a regular basis. A tank of gas should last about 4 hours under
100% load, and about 8 hours under 50% load. See engine owner's manual for more detail.
WARNING :
A running engine is hot enough to ignite fuel. Never add fuel or remove fuel tank cap if
engine is running or still hot. Let cool at least 2 minutes.
b) Check engine oil level each time you refuel.
c) Change oil after the first 20 operating hours, and at least every 100 operating hours
thereafter, as directed in the engine owner's manual.
WARNING:
Never open oil port while engine is running. Hot oil can spray over face and body.
Operation (cont'd)

3. Starting the Engine

26