Operation - Fujitsu AOY9FSBC Operating Manual

OPERATION

To Select Mode Operation
1 Press the START/STOP button (Fig.6 R).
The indoor unit's OPERATION indicator lamp (red) (Fig. 3 5) will light.
The air conditioner will start operating.
2 Press the MASTER CONTROL button (Fig.6 J) to se-
lect the desired mode.
Each time the button is pressed, the mode will change in the following
order.
s
AUTO
About three seconds later, the entire display will reappear.
To Set the Thermostat
Press the SET TEMP. buttons (Fig. 6 K).
button: Press to raise the thermostat setting.
button: Press to lower the thermostat setting.
GThermostat setting range:
AUTO .................................. Standard temperature setting ± 2 °C
Cooling/Dry ........................ 18-30 °C
FAN ..................................... 17-30 °C
(During use of FAN mode, if the thermostat is set at 17 °C or lower, the display will
show "--" and the fan will operate continuously, regardless of the room temperature.)
About three seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ
somewhat from the actual room temperature.
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 6 Q).
Each time the button is pressed, the fan speed changes in the following order:
s AUTO s HIGH
About three seconds later, the entire display will reappear.
When set to AUTO:
Cooling : As the room temperature approaches that of the thermostat setting,
the fan speed becomes slower.
Fan : The fan will operate at the optimum speed in accordance with the
room temperature in the vicinity of the indoor unit.
When set to QUIET:
SUPER QUIET operation begins. The indoor unit's airflow will be reduced for quieter
operation.
G SUPER QUIET operation cannot be used during Dry mode. (The same is true
when dry mode is selected during AUTO mode operation.)
G Cooling performance will be reduced somewhat during SUPER QUIET operation.
En-5
s s s
COOL DRY FAN
s MED s LOW
Example: When set to COOL.
Example: When set to 26 °C.
QUIET
s
Example: When set to AUTO.