Jacuzzi J-VSP Programming Manual

Jacuzzi J-VSP Programming Guide
Changing Programmed Speeds:
IMPORTANT: Programming speeds must be performed in the ON position.
The Jacuzzi VS Pump is factory programmed at the following
speeds:
• LOW: 1200 RPM
• MED: 2300 RPM
• HIGH: 3075 (1.5 HP) or 3450 (2.5 HP)
To increase or decrease speeds:
1. Select desired speed (LOW, MED, or HIGH)
2. Use the UP or DOWN arrows to change speed in 25 RPM increments.
IMPORTANT: The following programming can only be completed in the OFF position.
Programming Priming Mode:
Features of the J-VSP Priming Mode include:
• Completely programmable run time and RPM
• May be utilized as a specialty timer period for additional circulation and filtration
• Priming mode can be programmed from 2 to 120 minutes, and from 600 RPM to 3075 (1.5 HP) or
3450 (2.5 HP)
To Program:
1. Press MENU until PRIM appears on display.
2. Press ENTER to edit.
3. Press the UP or DOWN arrow to change RPM. When finished, press ENTER.
4. Press UP or DOWN arrow to change minutes. When finished, press ENTER. This will return you
to the Main Menu.