Frigidaire FDFE12GFAW6 User Manual page 9

1. Turn the knob until the programme marker is aligned with
appliance is in programme selection mode.
2. Press and hold the Delay button until the start indicator and the on/off indicator start to
flash.
3. Press Delay button the
• The intermittent flashing of
5 flashes = level 5.
4. Press the Delay button again and again to change the setting. Each time you press the
Delay button the level number increases.
5. To confirm the setting and deactivate the appliance, turn the knob until the programme
marker is aligned with the on/off indicator.
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water softener.
Contact your local water authority to
know the water hardness in your
area.
2. Fill the salt container with special salt
for dishwasher.
Adding salt
Before first use put one litre of water in the salt container.
Water and salt can come out from the salt container when you fill it. Risk of corrosion. To
prevent it, after you fill the salt container, start a programme.
Adding rinse aid
start to flash.
refers to the current set level,, e.g. 5 flashes + pause +
1
2
BEFORE FIRST USE
3. Fill the rinse aid dispenser with special
rinse aid for dishwasher.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
. Make sure that the
9