Uc Open Xp Installation; To Install The Uc Open Xp Into An I-Vu Open Control System - Carrier UC Open XP Installation And Startup Manual

UC Open XP installation

UC Open XP installation
To install the UC Open XP:
Mount the controller. (page 9)
1
Wire the controller for power. (page 10)
2
Set the controller's address. (page 10)
3
Wire expanders to the controller. (page 18)
4
Wire inputs and outputs (page 13).
5
Wire sensors to the controller. (page 23)
6

To install the UC Open XP into an i-Vu Open Control System

You must complete the following procedures to successfully install your UC Open XP into an i-Vu Open Control
System. Use the Help in the referenced software for detailed descriptions of these procedures.
ApplicationBuilder or Snap
Use ApplicationBuilder or Snap to create control program(s) for your UC Open XP.
1
If applicable, print the Sequence of Operation created by ApplicationBuilder, which includes the points
2
list.
NOTE You can create a points list under Reports in Field Assistant after installing your control program.
UC Open XP Installation Guide
Prepare a wire list using the points list. Refer to the Appendix (page 29).
1
Use the wire list and the following installation procedures to install and wire I/O points to your UC Open
2
XP and expander, if applicable.
i-Vu/Field Assistant
Complete the Discovery process to upload the controller to the database.
1
In Discovery > Setup, select Add Control Program, upload control program and graphic to i-Vu/FA, then
2
download to the controller.
Select the controller in the navigation tree and go to Properties page > I/O Points tab to assign channel
3
numbers to the physical points.
NOTE 39m AHU Equipment has pre-assigned IO channels. See Appendix B (page 33). You must assign
IO channels in all other applications by:
Entering your channel numbers under Num, using your wire list
○
Entering your expander address under Exp, if applicable
○
Selecting the appropriate value under Sensor/Actuator Type, if applicable
○
8 UC Open XP/UC Open XP IO