Program Change; Program End - AEG T8DHC876C User Manual

The appliance starts and the LED above the button stops flashing
and stays on.

10.10 Program change

To change a program:
1. Push the On/Off button to turn the appliance off.
2. Push the On/Off button again to turn on the appliance.
3. Set a new program.

10.11 Program end

Clean the filter and drain the water container after each drying
cycle. (See chapter CARE AND CLEANING.)
If the drying cycle is finished, the symbol
If the Buzzer option is activated, the acoustic signal sounds
intermittently for 1 minute.
If you do not turn off the appliance, the anti-crease phase starts
(not active with all programs). Flashing
execution of the anti-crease phase. Laundry can be removed
during this phase.
To remove the laundry:
1. Push the On/Off button for 2 seconds to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying results:
• Inadequate default dryness level settings. See chapter
Adjustment of default dryness level
• Room temperature is too low or too high. Optimal room
temperature is between 18°-25°C.
DAILY USE
appears on the display.
symbol signals the
37/64