Table of Contents
Advertisement
ASSEMBLE THE FOLLOWING COMPONENTS TO THE PC BOARD
R4 - 330kW Resistor
(org-org-yel-gold)
R1 - 330W Resistor
(org-org-brn-gold)
R3 - 33kW Resistor
R2 - 33kW Resistor
(org-org-org-gold)
R13 - 1kW Resistor
(brn-blk-red-gold)
R12 - 10kW Resistor
(brn-blk-org-gold)
R11 - 100kW Resistor
(brn-blk-yel-gold)
R14 - 100W Resistor
(brn-blk-brn-gold)
Figure A
Jumper Wire
Form
jumper
wire
from
a
discarded
resistor lead.
Figure D
Flat
Spacer
Mount with the flat side of
LED as shown in the top
legend of the PC board.
Figure B
Flat
Mount with the flat side of the
transistor as shown on the top legend
of the PC board. Leave 1/8" between
the part and PC board.
Figure E
Insert the IC socket
into the PC board
with the notch in the
direction shown on
the
top
legend.
Solder the IC socket
into place. Insert the
IC into the socket with
the notch in the same
direction as the notch
on the socket.
Polarity
Mark
(–)
Be sure that the positive lead is in the correct hole
as shown on the PC board. Bend the electrolytic
over and solder into place.
Band
Notch
Diodes have polarity, so be sure that the band is
in the correct direction, as shown on the top
legend of the PC board.
-3-
J1 - Jumper Wire
(see Figure A)
R5 - 220W Resistor
R6 - 220W Resistor
(red-red-brn-gold)
R9 - 47kW Resistor
(yel-vio-org-gold)
R8 - 18kW Resistor
(brn-gray-org-gold)
R7 - 5.6kW Resistor
(grn-blue-red-gold)
R10 - 330W Resistor
(org-org-brn-gold)
SAVE 3 CUT-OFF
RESISTOR LEADS
Figure C
(+)
Figure F
D1
Advertisement
Table of Contents
