Kallista PERFECT P74235-WO-0 Installation Manual

Record your model number below
for future reference:
Use the anchors and fasteners
provided by the countertop
manufacturer and the clamps
provided with your sink.
DO NOT use adhesives or adhesive
sealants to install this sink.
5 Position the lavatory squarely
under the cutout. Draw the
lavatory rim up against the
countertop until it is snug. Hold the
sink in place and rotate each clip
over the rim. Evenly tighten the
clips to secure.
1300842-2-B
Observe all local plumbing and
building codes.
Verify cabinet clearance.
1
6 Immediately wipe away any
excess sealant. Allow the sealant
to set for 30 minutes before
proceeding.
CAUTION: Risk of personal
injury.
Product can break, chip, and cause
injury if handled carelessly. Get help
lifting the lavatory.
Clean the underside of the
2
countertop and the rim of the sink.
7 Complete the faucet and drain
installations.
IMPORTANT! Provide your
countertop manufacturer with your
lavatory model number. Countertop
manufacturer should preinstall the
anchors into the underside of the
countertop.
Loosely install the clips.
3
8 Run water into the sink and check
all connections for leaks.
100% Silicone Sealant
IMPORTANT! Risk of product
damage. Overtightening the nuts
may cause irreparable damage to
the lavatory.
Generously apply 100% silicone
4
sealant around the rim.