Download Print this page
Dimplex Coldwatcher MPH 500 Instruction Manual

Dimplex Coldwatcher MPH 500 Instruction Manual

Convector heater

Advertisement

Quick Links

INSTRUCTION MANUAL
Installation and Operating
Coldwatcher Convector Heater
Models: MPH 500 & MPH 1000
These instructions should be read carefully and
retained for future use. Note also the information
presented on the appliance.
08/16283/0
ISSUE: 10

Advertisement

loading

Summary of Contents for Dimplex Coldwatcher MPH 500

  • Page 1 INSTRUCTION MANUAL Installation and Operating Coldwatcher Convector Heater Models: MPH 500 & MPH 1000 These instructions should be read carefully and retained for future use. Note also the information presented on the appliance. 08/16283/0 ISSUE: 10...
  • Page 2: Important Safety Advice

    IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/ OR DAMAGE AND MAY INVALIDATE YOUR GUARANTEE IMPORTANT SAFETY ADVICE WARNING - This appliance must not be used in a bathroom. WARNING - To ensure safe operation, the heater may only be installed and connected in accordance with these installation and operating instructions.
  • Page 3 WARNING - The device carried the sticker on the top, which indicates that the heating device must under no circumstances be covered with any objects. Do not expose the appliance to direct rainfall. The appliance is not for outdoor use unless sheltered under cover.
  • Page 4: Installation

    Suitable for fixed mounting on the wall or floor, they can also be used free-standing in a vertical or horizontal position. For maximum heating effectiveness the heater should be positioned as low as possible within the area to be heated. Note: If the heater is to be used unattended for long periods (e.g.
  • Page 5: Fixing To The Floor

    Step 1 1 0 0 Upper Wall Fixing Bracket Step 2 wall bracket notches against these fixing points to check that the heater complies with the “minimum operating distances”. Step 1 1 0 0 These two fixing points should then be drilled and plugged. Suitable round headed size 8 screws should be fixed in these positions to such a depth that the heater may be hung in Upper Wall Fixing Bracket...
  • Page 6 THERMAL OVERLOAD CUT-OUT The built-in overheat cut-out switches off the appliance automatically in the event of a fault. Disconnect the electricity supply to the appliance. After a short cooling down phase, the appliance is ready for use again. If the fault should occur again, follow the advice in the “After Sales Service”...
  • Page 7 All Dimplex products are individually tested before leaving the factory. If you are a consumer and you experience a problem with your Dimplex product, which is found to be defective due to faulty materials or workmanship within the Guarantee Period, this Dimplex Guarantee will cover repair or - at the discretion of Dimplex –...
  • Page 8 If you do experience a problem with your Dimplex product please call the Helpline on 0844 879 3588 or visit http://www.dimplex.co.uk/about-us/contact-us/ and complete the online form. For ROI please email serviceireland@glendimplex.com or call +353(0)1 842 833. We will need details of your Dimplex product, its serial number and a description of the fault which has occurred.

This manual is also suitable for:

Coldwatcher mph 1000