Cabinet Installation - LG LW1016ER Owner's Manual

Cabinet Installation

Center Hole Center Hole
1
Open the window. Mark a line on the center of
the inside sill.
Carefully place the cabinet in the window and
align the center hole on the cabinet bottom
front with the center line on the sill.
2
Pull the bottom window sash down behind the
upper guide until It meets the cabinet.
NOTE
• Do not pull the window sash down so tightly
that the movement of the curtain panels is
restricted.
3
Loosely assemble each sill support.
NOTE
• If the distance to the outer window sill is not
that deep, you may not need the bolt and nut.
Inside Sill Inside Sill
Outside Sill Outside Sill
Inside Sill Inside Sill
Center Hole Center Hole
Window Sash Window Sash
Upper Panel Upper Panel
Guide Guide
Sill Support Sill Support
Nut Nut
Bolt Bolt
4
Use 2 type A screws to attach a sill support
to the cabinet track holes on one side. Use
the cabinet track holes that will place the sill
support nearest to the outer edge of the sill.
The longer side of the sill support should be
facing outside the window.
Repeat with the second sill support on the
opposite side of the cabinet.
5
Install the cabinet with a slight tilt (about 1/2")
downward on the outside.
Use the bolt and nut to adjust the tilt of the
cabinet.
CAUTION
• Do not drill a hole in the bottom pan.
The product is designed to operate with
approximately 1/2" of water in the bottom pan.
There is no need to add water if the pan is dry.
Cabinet Track Holes Cabinet Track Holes
Screws (Type A) Screws (Type A)
Outdoor Outdoor
Indoor Indoor
about 1/2" about 1/2"
Cabinet Cabinet
EN
13