Craftsman 944.363391 Owner's Manual page 13

TO REMOVE DRIVE BELT
1. Remove drive cover and belt keeper.
2. Remove belt from gearcase pulley by
push ing down on pulley and rolling belt
off it.
3. Turn lawn mower on its side with air
fi lter and car bu re tor down.
4. Remove blade and debris shield.
5. Remove belt from engine pulley on
crankshaft.
TO REPLACE DRIVE BELT
1. Install new belt on engine pulley.
2. Reinstall debris shield and blade.
3. Return mower to upright po si tion.
4. Install new belt on gearcase pulley.
5. Reinstall belt keeper and drive cover.
NOTE: Always use factory approved belt
to assure fi t and long life.
Drive
cover Belt
Belt keeper
PUSH DOWN
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and wire tie(s)
securing cable(s) to lower handle.
2. Remove hairpin cotters from lower
handle bracket mount ing pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeeze lower handle in and position
holes onto mount ing pins on handle
bracket.
6. Reassemble upper handle and all
parts removed from lower handle.
Lower
handle
ROTATE
Mowing
position
Hairpin
cotter
Mounting
pin
LOW POSITION
ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that the engine is running too fast
or too slow, take your lawn mower to a
Sears or other qualifi ed service center for
repair and adjustment.
CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate properly due to
suspected carburetor problems, take your
lawn mower to a Sears or other qualifi ed
service center for repair or ad just ment.
IMPORTANT: Never tamper with the
engine governor, which is factory set
for proper engine speed. Over speed ing
the engine above the factory high speed
setting can be dangerous. If you think
the engine-governed high speed needs
adjusting, contact a Sears or other
qualifi ed service center, which has proper
equip ment and ex pe ri ence to make any
nec es sary adjustments.
13
Mowing
position
Handle
bracket
HIGH POSITION