Table of Contents
Advertisement
Learn a remote control
A remote control is useful for operating the controller during setup.
Press and hold P2/RADIO until the red LED is lit. Press the main button on the remote
control. Wait 10 seconds to exit learning mode.
Install the CH-RADIO jumper. Press and hold P2/RADIO until the red LED is lit. Press the
second button on the remote control. Wait 10 seconds to exit learning mode. Remove the
CH-RADIO jumper.
Now the main remote button will act as P1, and the second button act as P2.
Set the limits of travel
Limit switches must be set before any further setup of the controller board.
Attach the limit switch actuating plates to the rack as required, such that when the gate is
in the fully open and fully closed positions, the limit switch on the drive is triggered.
12
Advertisement
Table of Contents
