Rear Panel - NETGEAR Nighthawk AD7200 User Manual

Rear Panel

The following figure shows the rear panel connectors and buttons.
Figure 3. Rear panel
Viewed from left to right, the rear panel contains the following components:
• LED On/Off switch. If this switch is in the Off position, the router's LEDs, including
the LEDs on the four active antennas, but not the Power LED, are turned off.
• Reset button. Pressing the Reset button resets the router.
If the Reset button is pressed for at least 10 seconds and the Power LED blinks white,
the router returns to its factory settings. For information about the factory settings,
see Factory Settings on page 220.
• Ethernet ports. Six Gigabit Ethernet RJ-45 LAN ports. Use these ports to connect
the router to LAN devices.
Ethernet port aggregation is enabled by default. Use Ethernet aggregate ports 1
and 2 to cable a device that supports Ethernet port aggregation to the router.
Ethernet ports 3, 4, 5, and 6 are nonaggregate Ethernet ports.
• Internet port. One yellow Gigabit Ethernet RJ-45 WAN port to connect the router
to an Internet modem such as a cable modem or DLS modem.
Hardware Setup
Nighthawk AD7200 Gaming Router Model XR700
15 User Manual