Specifications - Stihl MSA 220 C Instruction Manual

English
Fault LEDs on the
battery
Chainsaw run‐
time is too short.
Smell of smoke
or burning in the
cutting area.

19 Specifications

19.1 STIHL MSA 220 C Chainsaw
Approved batteries:
– STIHL AP
– STIHL AR
– Weight without battery, guide bar and saw
chain 2.9 kg
– Max. oil tank capacity: 210 cc (0.21 l)
For battery life see www.stihl.com/battery-life.
19.2 Chain Sprockets and Chain
Speeds
The following chain sprockets may be used:
6-tooth for 3/8" P
– Maximum chain speed according to
ISO 11681: 23.3 m/s
19.3 Minimum Groove Depth of
Guide Bars
The minimum groove depth depends on the pitch
of the guide bar.
– 3/8" P: 5 mm
19.4 STIHL AP battery
– Battery Technology: Lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Weight in kg: see rating label
– Permissible temperature range for operation
and storage: -10°C to +50°C
52
Cause
The battery is not fully
charged.
The battery life has
been exceeded.
The saw chain has
not been correctly
sharpened.
Insufficient saw chain
oil in the oil tank.
The chain lubrication
system is supplying
insufficient saw chain
oil.
The saw chain is
over-tensioned.
The chainsaw is not
being used properly.
19.5
The K-value for sound pressure levels is 2 dB(A).
K-value for sound power levels is 2 dB(A). The
K-value for vibration level is 2 m/s².
MSA 220 C 3/8" P
– Sound pressure level L
to EN 60745‑2‑13: 89 dB(A)
– Sound power level L
EN 60745-2-13: 100 dB(A)
– Vibration level a
EN 60745-2-13:
– Control handle: 3.6 m/s²
– Handlebar: 4.8 m/s²
The vibration levels indicated were measured
according to a standardized test method and can
be used as a basis for comparing electric power
tools. The vibration levels actually occurring may
vary from the values indicated, depending on the
type of application. The vibration levels indicated
can be used for an initial estimate of the vibration
stress. The actual vibration stress has to be esti‐
mated. The times when the electric power tool is
switched off and the times when it is switched on
but running under no load can be taken into
account in the estimate.
For information on compliance with Employers'
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
Remedy
► Recharge the battery fully as described in
the User Manual for the STIHL AL 101,
300, 500 chargers.
► Replace battery.
Sharpen chain as specified.
Fill up with saw chain oil.
Do not use the chainsaw. Consult a STIHL
dealer.
Tension the saw chain as specified.
Have correct use explained, then practice.
Sound Values and Vibration
Values
pA
measured according to
wA
measured according to
hv
19 Specifications
measured according
0458-795-9821-B