Installation 9 Door Removal - Samsung NV70H3350CB User Manual

Table of Contents

Advertisement

installation
Safety instructions for the installation
This oven may be installed only by an approved electrician. The installer is responsible for
connecting the appliance to the main supply, while observing the relevant safety regulations.
• Ensure protection from live parts when installing the oven.
Power connection
If the appliance is not connected to the mains with a plug, a multi-
pole isolator switch (with at least 3 mm contact spacing) must be
provided in order to satisfy safety regulations. The power cable
(H05 RR-F or H05 VV-F, min., 2.5 mm²) must be of sufficient
length to be connected to the oven, even if the oven stands on
the floor in front of its built-in cabinet. Open the rear connection
cover of the oven with a screwdriver and loosen the screws of the
cable clamp before you connect the power lines to the relevant
connection terminals. The oven is earthed via the (
The yellow and green cable(earth connection) must be connected first and be longer than the others. If the
oven is connected to the mains with a plug, this plug must remain accessible after the oven is installed.
Samsung will take no responsibility for accidents that originate from a missing or faulty earth connection.
WARNING: Do not allow the connecting cable to become trapped during installation, and
prevent it coming into contact with hot parts of the oven.
Installation in the cabinet
If installing the oven in a built-in cabinet, the cabinet must have its plastic surfaces and adhesive parts
resistant up to 90 °C. Samsung is not responsible for damage to furniture from the oven's heat emission.
The oven must be properly ventilated. For ventilation, leave a gap of about 50 mm between the lower
shelf of the cabinet and the supporting wall. If you install the oven under a cooktop, follow the cooktop's
installation instructions.
Min.550
370
560
Max.50
595
572
595
549
21
Built-in
Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make
sure that a gap of at least 5mm should be left between the appliance and the adjacent cabinet.
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside
of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and
release the 2 screws on the both sides of the oven.
NV70H3350CE_WT_DG68-00534A-05_EN.indd 8
Min.560
Min.50
Min.590 ~ Max.600
550
Min.460 x Min.50
English - 8
BROWN or
BLACK
)-terminal.
Min.550
175
370
560
115
595
550
Max.476
572
595
549
Max.464
21
BLUE or
YELLOW and
WHITE
GREEN
Min.560
Min.600
Min.460 x Min.50
Built-under
Built-in + Built-under
7/18/2018 3:08:59 PM

Advertisement

Table of Contents
loading

Table of Contents